EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1785071739	4 Count	159 Count
1785069939	39 Count	1001 Count
1785068138	33 Count	788 Count
1785066337	28 Count	676 Count
1785064536	22 Count	509 Count
1785062736	18 Count	404 Count
1785060935	9 Count	300 Count
1785059134	5 Count	191 Count
1785057333	1 Count	101 Count
1785055532	31 Count	1038 Count
1785053731	26 Count	936 Count
1785051938	22 Count	824 Count
1785050137	16 Count	677 Count
1785048337	12 Count	522 Count
1785046536	7 Count	368 Count
1785044735	4 Count	224 Count
1785042934	35 Count	1009 Count
1785041133	31 Count	847 Count
1785039333	23 Count	692 Count
1785037532	18 Count	541 Count
1785035731	13 Count	419 Count
1785033930	9 Count	294 Count
1785032130	3 Count	142 Count
1785030339	39 Count	1124 Count
1785028538	33 Count	999 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)