EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757863285	67 Count	465 Count	57 Count
1757862384	58 Count	397 Count	49 Count
1757861484	48 Count	327 Count	40 Count
1757860583	39 Count	270 Count	32 Count
1757859682	30 Count	198 Count	24 Count
1757858781	22 Count	125 Count	17 Count
1757857881	12 Count	49 Count	8 Count
1757857052	132 Count	1028 Count	123 Count
1757856151	123 Count	944 Count	115 Count
1757855251	113 Count	879 Count	106 Count
1757854350	103 Count	807 Count	97 Count
1757853449	89 Count	701 Count	84 Count
1757852548	71 Count	585 Count	67 Count
1757851648	52 Count	478 Count	49 Count
1757850747	34 Count	354 Count	32 Count
1757849846	19 Count	238 Count	18 Count
1757848945	10 Count	108 Count	10 Count
1757848044	89 Count	1045 Count	82 Count
1757847144	77 Count	838 Count	71 Count
1757846243	65 Count	636 Count	60 Count
1757845342	56 Count	534 Count	52 Count
1757844441	44 Count	422 Count	41 Count
1757843541	30 Count	300 Count	28 Count
1757842640	19 Count	200 Count	18 Count
1757841739	10 Count	94 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)