EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1764027088	22 Count	249 Count	19 Count
1764025287	13 Count	172 Count	12 Count
1764023486	7 Count	88 Count	7 Count
1764021685	87 Count	1015 Count	68 Count
1764019885	78 Count	930 Count	62 Count
1764018084	73 Count	826 Count	58 Count
1764016293	64 Count	717 Count	50 Count
1764014492	56 Count	618 Count	44 Count
1764012691	50 Count	541 Count	39 Count
1764010890	41 Count	459 Count	33 Count
1764009089	35 Count	398 Count	28 Count
1764007289	25 Count	326 Count	20 Count
1764005488	21 Count	271 Count	17 Count
1764003687	14 Count	173 Count	12 Count
1764001886	8 Count	84 Count	7 Count
1764000085	99 Count	1029 Count	80 Count
1763998284	94 Count	974 Count	76 Count
1763996483	89 Count	904 Count	72 Count
1763994691	83 Count	856 Count	67 Count
1763992890	72 Count	785 Count	60 Count
1763991089	66 Count	724 Count	55 Count
1763989288	59 Count	653 Count	49 Count
1763987487	50 Count	572 Count	42 Count
1763985686	43 Count	505 Count	36 Count
1763983885	36 Count	416 Count	31 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)