EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1751673915	94 Count	57 Count	6 Count
1751672715	73 Count	34 Count	4 Count
1751671514	49 Count	17 Count	2 Count
1751670313	24 Count	10 Count	1 Count
1751669127	1006 Count	239 Count	33 Count
1751667926	983 Count	229 Count	32 Count
1751666725	961 Count	219 Count	30 Count
1751660720	816 Count	174 Count	24 Count
1751659519	797 Count	165 Count	22 Count
1751658318	784 Count	156 Count	20 Count
1751657117	765 Count	145 Count	18 Count
1751655917	750 Count	136 Count	17 Count
1751654716	719 Count	125 Count	17 Count
1751653515	689 Count	115 Count	16 Count
1751652314	669 Count	108 Count	15 Count
1751651114	644 Count	101 Count	15 Count
1751649913	586 Count	92 Count	14 Count
1751648712	515 Count	86 Count	12 Count
1751647526	454 Count	79 Count	11 Count
1751646325	386 Count	70 Count	10 Count
1751645124	328 Count	62 Count	9 Count
1751640320	133 Count	25 Count	3 Count
1751639119	112 Count	16 Count	2 Count
1751637918	61 Count	6 Count	0 Count
1751636717	1031 Count	225 Count	29 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)