EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP6TK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6TK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1747614164	454 Count	363 Count	170 Count
1747612964	424 Count	343 Count	160 Count
1747611763	394 Count	318 Count	148 Count
1747610562	365 Count	298 Count	138 Count
1747609361	334 Count	270 Count	126 Count
1747608161	306 Count	245 Count	114 Count
1747606960	279 Count	226 Count	102 Count
1747605759	246 Count	202 Count	91 Count
1747603358	162 Count	157 Count	69 Count
1747602157	132 Count	130 Count	57 Count
1747600956	112 Count	108 Count	47 Count
1747599755	79 Count	85 Count	37 Count
1747599617	75 Count	85 Count	37 Count
1747599084	55 Count	77 Count	34 Count
1747597882	24 Count	56 Count	23 Count
1747596682	11 Count	27 Count	11 Count
1747595481	1009 Count	903 Count	348 Count
1747594280	979 Count	883 Count	338 Count
1747593079	967 Count	867 Count	333 Count
1747591878	958 Count	847 Count	329 Count
1747591254	952 Count	843 Count	328 Count
1747590053	948 Count	828 Count	325 Count
1747588852	934 Count	814 Count	321 Count
1747586451	829 Count	729 Count	289 Count
1747585250	789 Count	691 Count	279 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)