EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1789246314	681 Count	667 Count	568 Count
1789244514	670 Count	654 Count	558 Count
1789242713	660 Count	644 Count	549 Count
1789240912	642 Count	625 Count	532 Count
1789239111	633 Count	615 Count	524 Count
1789233709	609 Count	594 Count	503 Count
1789231908	602 Count	588 Count	497 Count
1789230108	595 Count	582 Count	491 Count
1789228315	584 Count	576 Count	485 Count
1789226514	573 Count	566 Count	475 Count
1789224713	565 Count	559 Count	468 Count
1789222913	558 Count	553 Count	462 Count
1789221112	553 Count	549 Count	458 Count
1789219311	545 Count	542 Count	451 Count
1789217510	537 Count	535 Count	444 Count
1789215710	530 Count	529 Count	438 Count
1789213909	518 Count	515 Count	427 Count
1789212108	509 Count	506 Count	419 Count
1789210307	501 Count	498 Count	412 Count
1789208506	484 Count	474 Count	396 Count
1789206714	470 Count	463 Count	387 Count
1789204913	458 Count	452 Count	376 Count
1789203112	446 Count	441 Count	365 Count
1789201311	438 Count	434 Count	358 Count
1789199511	432 Count	429 Count	353 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)