EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1788976298	476 Count	618 Count	354 Count
1788974497	471 Count	614 Count	350 Count
1788972696	466 Count	610 Count	346 Count
1788970895	461 Count	606 Count	342 Count
1788969103	453 Count	603 Count	339 Count
1788967302	445 Count	596 Count	332 Count
1788965501	440 Count	592 Count	328 Count
1788963700	435 Count	588 Count	324 Count
1788961900	430 Count	584 Count	320 Count
1788960099	426 Count	581 Count	317 Count
1788958298	421 Count	577 Count	313 Count
1788956497	414 Count	571 Count	307 Count
1788954696	408 Count	566 Count	302 Count
1788952896	397 Count	555 Count	292 Count
1788945701	373 Count	537 Count	276 Count
1788943900	368 Count	533 Count	272 Count
1788942099	363 Count	529 Count	268 Count
1788940298	358 Count	525 Count	264 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)