EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786934485	120 Count	259 Count	101 Count
1786932679	116 Count	254 Count	98 Count
1786930874	111 Count	246 Count	94 Count
1786929069	106 Count	240 Count	90 Count
1786927264	97 Count	228 Count	82 Count
1786925459	81 Count	209 Count	67 Count
1786923654	69 Count	185 Count	56 Count
1786921848	63 Count	172 Count	51 Count
1786920043	53 Count	157 Count	42 Count
1786918238	41 Count	137 Count	31 Count
1786916433	34 Count	121 Count	25 Count
1786914628	31 Count	105 Count	23 Count
1786912823	27 Count	92 Count	20 Count
1786911018	25 Count	85 Count	19 Count
1786909213	22 Count	75 Count	17 Count
1786907408	19 Count	66 Count	15 Count
1786905603	17 Count	55 Count	14 Count
1786903798	11 Count	40 Count	9 Count
1786901993	7 Count	24 Count	6 Count
1786900188	4 Count	17 Count	4 Count
1786898383	395 Count	1004 Count	334 Count
1786896578	392 Count	994 Count	332 Count
1786894772	387 Count	980 Count	328 Count
1786892966	384 Count	966 Count	326 Count
1786891161	380 Count	952 Count	323 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)