EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4WSL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4WSL-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1786722296	65 Count	69 Count	63 Count
1786720496	14 Count	14 Count	14 Count
1786718705	712 Count	1010 Count	672 Count
1786716904	692 Count	991 Count	653 Count
1786715103	669 Count	961 Count	631 Count
1786713303	655 Count	946 Count	618 Count
1786711502	640 Count	930 Count	604 Count
1786709701	608 Count	894 Count	573 Count
1786707901	589 Count	867 Count	555 Count
1786706100	573 Count	847 Count	540 Count
1786704299	557 Count	825 Count	525 Count
1786702499	541 Count	804 Count	510 Count
1786700698	525 Count	783 Count	495 Count
1786698898	509 Count	761 Count	480 Count
1786697104	493 Count	740 Count	465 Count
1786695304	479 Count	719 Count	452 Count
1786693503	463 Count	696 Count	437 Count
1786691702	447 Count	674 Count	422 Count
1786689902	431 Count	652 Count	407 Count
1786688101	412 Count	625 Count	389 Count
1786686300	382 Count	521 Count	360 Count
1786684500	364 Count	431 Count	343 Count
1786682699	348 Count	410 Count	328 Count
1786680899	332 Count	390 Count	313 Count
1786679098	317 Count	370 Count	299 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)