EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1772247735	0 Count	0 Count
1772244168	28 Count	1000 Count
1772240565	26 Count	906 Count
1772236962	24 Count	820 Count
1772233359	22 Count	722 Count
1772229756	20 Count	627 Count
1772226153	17 Count	547 Count
1772222552	15 Count	469 Count
1772218947	13 Count	431 Count
1772215344	11 Count	359 Count
1772211741	9 Count	289 Count
1772208138	7 Count	226 Count
1772204536	5 Count	156 Count
1772200967	3 Count	113 Count
1772197364	1 Count	62 Count
1772193761	29 Count	1032 Count
1772190158	27 Count	980 Count
1772186555	25 Count	926 Count
1772182951	23 Count	892 Count
1772179349	21 Count	831 Count
1772175746	19 Count	797 Count
1772172143	17 Count	751 Count
1772168540	15 Count	684 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)