EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767277493	113 Count	541 Count	25 Count
1767275692	108 Count	509 Count	24 Count
1767273891	101 Count	484 Count	20 Count
1767272091	92 Count	459 Count	15 Count
1767270290	86 Count	435 Count	13 Count
1767268489	81 Count	412 Count	11 Count
1767266689	64 Count	368 Count	5 Count
1767264888	47 Count	318 Count	5 Count
1767261287	41 Count	257 Count	5 Count
1767259486	37 Count	223 Count	5 Count
1767257693	30 Count	193 Count	5 Count
1767255892	26 Count	168 Count	5 Count
1767252291	17 Count	114 Count	4 Count
1767250491	14 Count	86 Count	4 Count
1767248689	9 Count	58 Count	3 Count
1767246889	4 Count	33 Count	2 Count
1767245088	234 Count	1025 Count	131 Count
1767243287	230 Count	997 Count	130 Count
1767241486	226 Count	967 Count	130 Count
1767239686	223 Count	938 Count	130 Count
1767237885	218 Count	907 Count	129 Count
1767236092	208 Count	871 Count	127 Count
1767234291	204 Count	839 Count	126 Count
1767232491	200 Count	815 Count	126 Count
1767230690	196 Count	788 Count	126 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)