EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767970525	289 Count	1078 Count	214 Count
1767968724	242 Count	974 Count	171 Count
1767966923	216 Count	898 Count	148 Count
1767965122	202 Count	834 Count	138 Count
1767963321	177 Count	755 Count	117 Count
1767961521	152 Count	678 Count	96 Count
1767959720	142 Count	620 Count	89 Count
1767957919	123 Count	562 Count	76 Count
1767956119	98 Count	489 Count	60 Count
1767954318	90 Count	442 Count	55 Count
1767952517	77 Count	396 Count	45 Count
1767950717	70 Count	366 Count	39 Count
1767948924	59 Count	324 Count	33 Count
1767947123	53 Count	289 Count	28 Count
1767945323	45 Count	254 Count	22 Count
1767943522	30 Count	179 Count	14 Count
1767941721	24 Count	144 Count	11 Count
1767939920	13 Count	95 Count	7 Count
1767938119	4 Count	52 Count	2 Count
1767936318	188 Count	1044 Count	135 Count
1767934518	182 Count	990 Count	133 Count
1767932717	176 Count	938 Count	130 Count
1767930916	172 Count	889 Count	128 Count
1767929115	168 Count	838 Count	125 Count
1767927324	160 Count	799 Count	122 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)