EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8KZI-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KZI-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1767316484	211 Count	976 Count	134 Count
1767276868	130 Count	902 Count	89 Count
1767269675	115 Count	890 Count	82 Count
1767267874	111 Count	884 Count	79 Count
1767266073	108 Count	879 Count	77 Count
1767264273	104 Count	873 Count	74 Count
1767262470	99 Count	865 Count	70 Count
1767260669	95 Count	859 Count	67 Count
1767258869	90 Count	852 Count	63 Count
1767257068	86 Count	845 Count	60 Count
1767255267	82 Count	836 Count	57 Count
1767253475	74 Count	830 Count	54 Count
1767251675	69 Count	824 Count	50 Count
1767249874	65 Count	818 Count	47 Count
1767248073	61 Count	811 Count	44 Count
1767246271	57 Count	805 Count	41 Count
1767244471	53 Count	798 Count	38 Count
1767242670	49 Count	790 Count	35 Count
1767240870	44 Count	781 Count	31 Count
1767239068	40 Count	720 Count	28 Count
1767237267	36 Count	489 Count	25 Count
1767235466	32 Count	430 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)