EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1743778675	42 Count	244 Count	33 Count
1743777774	39 Count	223 Count	32 Count
1743776874	36 Count	205 Count	30 Count
1743775973	20 Count	170 Count	15 Count
1743775072	13 Count	143 Count	9 Count
1743774172	5 Count	102 Count	2 Count
1743773271	3 Count	50 Count	1 Count
1743772370	2 Count	34 Count	1 Count
1743771470	0 Count	23 Count	0 Count
1743770569	101 Count	1017 Count	51 Count
1743769669	99 Count	988 Count	50 Count
1743768768	98 Count	960 Count	50 Count
1743767867	94 Count	913 Count	47 Count
1743766967	71 Count	866 Count	25 Count
1743766066	67 Count	839 Count	22 Count
1743764999	66 Count	839 Count	22 Count
1743764098	63 Count	812 Count	20 Count
1743763197	60 Count	783 Count	19 Count
1743762296	57 Count	753 Count	17 Count
1743761396	55 Count	723 Count	16 Count
1743760493	52 Count	697 Count	14 Count
1743749048	30 Count	394 Count	10 Count
1743748148	29 Count	377 Count	10 Count
1743747247	27 Count	358 Count	9 Count
1743746346	26 Count	341 Count	9 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)