EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9S-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9S-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1781149619	39 Count	241 Count
1781147819	38 Count	235 Count
1781146018	37 Count	229 Count
1781144218	36 Count	222 Count
1781142423	31 Count	213 Count
1781140622	30 Count	201 Count
1781138822	29 Count	195 Count
1781137021	28 Count	187 Count
1781135221	27 Count	180 Count
1781133420	26 Count	174 Count
1781131619	25 Count	168 Count
1781129819	24 Count	160 Count
1781128019	23 Count	154 Count
1781126218	22 Count	147 Count
1781124417	21 Count	141 Count
1781120822	15 Count	120 Count
1781119021	14 Count	109 Count
1781117221	13 Count	99 Count
1781115420	12 Count	89 Count
1781113620	11 Count	82 Count
1781111819	10 Count	72 Count
1781110019	9 Count	60 Count
1781108218	8 Count	49 Count
1781106418	7 Count	42 Count
1781104617	6 Count	30 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)