EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6EFY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6EFY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1751761075	939 Count	586 Count	583 Count
1751759869	934 Count	583 Count	580 Count
1751758662	930 Count	581 Count	578 Count
1751757456	924 Count	577 Count	574 Count
1751756250	919 Count	574 Count	571 Count
1751755045	914 Count	571 Count	568 Count
1751753839	908 Count	567 Count	564 Count
1751752633	903 Count	564 Count	561 Count
1751751427	898 Count	561 Count	558 Count
1751750221	892 Count	557 Count	554 Count
1751749015	887 Count	554 Count	551 Count
1751747809	882 Count	551 Count	548 Count
1751746603	876 Count	547 Count	544 Count
1751745397	871 Count	544 Count	541 Count
1751745341	870 Count	544 Count	541 Count
1751744513	866 Count	542 Count	539 Count
1751743412	861 Count	539 Count	536 Count
1751742206	856 Count	536 Count	533 Count
1751741000	850 Count	532 Count	529 Count
1751739794	845 Count	529 Count	526 Count
1751738588	839 Count	525 Count	522 Count
1751737382	834 Count	522 Count	519 Count
1751736176	828 Count	518 Count	515 Count
1751734971	822 Count	514 Count	511 Count
1751733765	817 Count	511 Count	508 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)