EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1742411608	6 Count	108 Count	6 Count
1742409807	94 Count	886 Count	75 Count
1742408906	83 Count	800 Count	65 Count
1742408005	65 Count	689 Count	48 Count
1742407104	63 Count	650 Count	47 Count
1742406204	60 Count	614 Count	45 Count
1742405303	57 Count	585 Count	43 Count
1742404402	55 Count	547 Count	42 Count
1742403501	50 Count	512 Count	41 Count
1742402601	47 Count	475 Count	39 Count
1742401700	44 Count	444 Count	37 Count
1742400799	39 Count	386 Count	35 Count
1742399898	23 Count	246 Count	20 Count
1742398998	16 Count	193 Count	14 Count
1742398097	10 Count	108 Count	9 Count
1742397196	1 Count	35 Count	1 Count
1742396295	128 Count	1046 Count	84 Count
1742395395	125 Count	979 Count	82 Count
1742394494	122 Count	949 Count	80 Count
1742393593	119 Count	917 Count	78 Count
1742392692	117 Count	884 Count	77 Count
1742391792	96 Count	782 Count	57 Count
1742390890	93 Count	705 Count	55 Count
1742389990	91 Count	665 Count	54 Count
1742389089	89 Count	634 Count	53 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)