EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR2ZYT-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR2ZYT-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1751575290	869	591	396	420	0
1751573492	866	588	394	421	0
1751571694	863	585	392	421	0
1751569896	860	582	390	421	58
1751568096	859	582	390	421	276
1751566297	856	579	388	421	276
1751564498	853	577	386	422	275
1751562697	852	577	386	422	223
1751557300	847	574	384	421	275
1751555499	846	574	384	422	221
1751553700	844	573	383	420	275
1751551900	843	573	383	422	220
1751550101	842	573	383	419	275
1751548303	840	572	382	420	222
1751546504	839	572	382	419	275
1751544708	836	570	380	419	275
1751542908	835	569	380	419	275
1751541110	834	569	380	421	220
1751539312	832	567	379	421	220
1751537514	831	567	379	419	222
1751535716	830	567	379	419	275
1751533918	827	565	377	419	276
1751532120	826	564	377	419	275
1751530321	824	563	376	419	275
1751528522	822	562	375	421	220

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)