EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

3Z2T-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1768018993	54	768	423	16
1768017194	53	752	423	16
1768015395	52	739	423	16
1768013595	51	721	423	16
1768011796	50	705	423	16
1768009996	49	693	423	16
1768008197	48	681	423	16
1768006398	47	669	423	16
1768004599	46	649	424	16
1768002799	45	633	424	16
1768001000	44	621	424	16
1767999201	43	609	424	16
1767997401	42	597	424	16
1767995602	41	579	425	16
1767993804	40	565	425	16
1767992005	39	525	425	16
1767990205	38	508	425	16
1767988407	37	496	425	16
1767986607	36	483	425	16
1767984808	35	470	425	16
1767983010	34	453	425	16
1767981211	33	441	425	16
1767979411	32	429	426	16
1767977611	31	412	426	16
1767975811	30	398	426	16

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)