EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762379302	191 Count	357 Count	168 Count
1762375700	183 Count	342 Count	162 Count
1762373900	179 Count	336 Count	159 Count
1762364897	149 Count	289 Count	135 Count
1762363122	144 Count	285 Count	134 Count
1762361321	142 Count	280 Count	133 Count
1762359521	139 Count	275 Count	131 Count
1762357720	130 Count	242 Count	123 Count
1762354120	121 Count	204 Count	116 Count
1762352319	109 Count	192 Count	105 Count
1762350518	85 Count	157 Count	82 Count
1762348717	57 Count	109 Count	55 Count
1762346916	37 Count	69 Count	36 Count
1762345116	18 Count	35 Count	18 Count
1762343315	605 Count	1009 Count	573 Count
1762341515	582 Count	971 Count	551 Count
1762339714	564 Count	924 Count	534 Count
1762337913	538 Count	868 Count	509 Count
1762336113	517 Count	822 Count	489 Count
1762334312	495 Count	779 Count	468 Count
1762332511	475 Count	736 Count	449 Count
1762330711	453 Count	693 Count	428 Count
1762328910	434 Count	651 Count	410 Count
1762327109	407 Count	616 Count	384 Count
1762325309	385 Count	586 Count	363 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)