EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767310414	6 Count	55 Count	3 Count
1767309213	4 Count	41 Count	2 Count
1767308012	2 Count	27 Count	1 Count
1767306812	0 Count	13 Count	0 Count
1767303209	124 Count	977 Count	63 Count
1767302006	122 Count	963 Count	62 Count
1767298418	113 Count	918 Count	60 Count
1767297217	111 Count	896 Count	59 Count
1767293616	106 Count	853 Count	57 Count
1767292416	104 Count	841 Count	56 Count
1767290011	100 Count	817 Count	54 Count
1767286409	95 Count	773 Count	52 Count
1767284009	91 Count	718 Count	50 Count
1767282809	89 Count	698 Count	49 Count
1767281606	88 Count	680 Count	49 Count
1767280408	86 Count	654 Count	48 Count
1767279206	84 Count	638 Count	47 Count
1767276815	76 Count	604 Count	45 Count
1767275614	74 Count	582 Count	44 Count
1767274415	73 Count	571 Count	44 Count
1767273215	71 Count	555 Count	43 Count
1767272012	69 Count	533 Count	42 Count
1767270813	67 Count	516 Count	41 Count
1767268412	63 Count	480 Count	39 Count
1767267209	61 Count	456 Count	38 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)