EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1772060492	119 Count	882 Count	61 Count
1772058090	113 Count	822 Count	57 Count
1772056891	109 Count	797 Count	54 Count
1772055691	105 Count	764 Count	51 Count
1772054490	101 Count	736 Count	48 Count
1772053287	98 Count	709 Count	46 Count
1772052089	95 Count	678 Count	44 Count
1772050888	91 Count	648 Count	41 Count
1772049685	87 Count	620 Count	38 Count
1772048486	84 Count	584 Count	36 Count
1772046083	77 Count	536 Count	31 Count
1772042494	65 Count	450 Count	26 Count
1772041294	63 Count	432 Count	25 Count
1772040091	60 Count	418 Count	23 Count
1772038892	57 Count	394 Count	21 Count
1772037692	55 Count	378 Count	20 Count
1772036489	53 Count	359 Count	19 Count
1772035290	52 Count	342 Count	19 Count
1772034090	50 Count	326 Count	18 Count
1772032887	48 Count	309 Count	17 Count
1772031688	46 Count	273 Count	16 Count
1772030488	41 Count	216 Count	12 Count
1772029287	38 Count	172 Count	10 Count
1772028084	35 Count	147 Count	8 Count
1772026886	34 Count	129 Count	8 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)