EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757862306	362 Count	852 Count	311 Count
1757860505	356 Count	838 Count	307 Count
1757858712	348 Count	823 Count	303 Count
1757856912	343 Count	811 Count	299 Count
1757855111	338 Count	793 Count	295 Count
1757853310	332 Count	767 Count	290 Count
1757851510	328 Count	754 Count	287 Count
1757849709	323 Count	738 Count	283 Count
1757847908	317 Count	722 Count	278 Count
1757846107	308 Count	701 Count	271 Count
1757844307	301 Count	679 Count	265 Count
1757842506	293 Count	658 Count	259 Count
1757840705	288 Count	638 Count	255 Count
1757838904	272 Count	599 Count	241 Count
1757837111	249 Count	558 Count	224 Count
1757835311	216 Count	489 Count	192 Count
1757833510	186 Count	431 Count	164 Count
1757831709	144 Count	345 Count	124 Count
1757829909	92 Count	242 Count	74 Count
1757826307	49 Count	140 Count	35 Count
1757824506	40 Count	118 Count	29 Count
1757822704	32 Count	93 Count	22 Count
1757820904	26 Count	71 Count	18 Count
1757819103	18 Count	48 Count	12 Count
1757817302	9 Count	24 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)