EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1769026833	137 Count	948 Count
1769023231	133 Count	923 Count
1769021431	131 Count	912 Count
1769019630	129 Count	899 Count
1769017829	127 Count	887 Count
1769016029	124 Count	873 Count
1769014259	119 Count	854 Count
1769012459	118 Count	842 Count
1769010658	116 Count	831 Count
1769007057	112 Count	800 Count
1769005256	110 Count	787 Count
1769003455	108 Count	776 Count
1769001654	106 Count	768 Count
1768999853	105 Count	756 Count
1768998053	103 Count	743 Count
1768994451	97 Count	710 Count
1768992651	95 Count	700 Count
1768990850	93 Count	686 Count
1768989050	91 Count	672 Count
1768987249	90 Count	658 Count
1768985448	88 Count	645 Count
1768983647	86 Count	637 Count
1768981847	84 Count	630 Count
1768980046	82 Count	616 Count
1768978246	80 Count	606 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)