EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793049782	977 Count	816 Count	698 Count
1793047977	974 Count	814 Count	696 Count
1793046171	971 Count	812 Count	694 Count
1793044366	968 Count	810 Count	692 Count
1793042561	965 Count	808 Count	690 Count
1793040757	962 Count	806 Count	688 Count
1793038949	959 Count	804 Count	686 Count
1793037144	946 Count	792 Count	674 Count
1793035339	938 Count	785 Count	667 Count
1793033534	921 Count	769 Count	651 Count
1793031729	918 Count	767 Count	649 Count
1793029924	915 Count	765 Count	647 Count
1793028119	912 Count	763 Count	645 Count
1793026314	909 Count	761 Count	643 Count
1793024509	906 Count	759 Count	641 Count
1793022704	903 Count	757 Count	639 Count
1793020899	896 Count	749 Count	633 Count
1793019094	893 Count	744 Count	631 Count
1793017290	891 Count	734 Count	630 Count
1793015485	887 Count	723 Count	628 Count
1793013680	885 Count	713 Count	627 Count
1793011875	882 Count	704 Count	625 Count
1793010070	879 Count	696 Count	623 Count
1793008265	876 Count	686 Count	621 Count
1793006460	873 Count	682 Count	619 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)