EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789240518	395 Count	885 Count	193 Count
1789240218	393 Count	881 Count	193 Count
1789239917	390 Count	873 Count	191 Count
1789239616	387 Count	867 Count	190 Count
1789239315	385 Count	865 Count	189 Count
1789239014	382 Count	858 Count	188 Count
1789238713	379 Count	852 Count	186 Count
1789238413	377 Count	847 Count	186 Count
1789238112	374 Count	839 Count	184 Count
1789237811	371 Count	831 Count	183 Count
1789237510	369 Count	828 Count	182 Count
1789237209	366 Count	821 Count	181 Count
1789236908	363 Count	815 Count	179 Count
1789236607	361 Count	811 Count	179 Count
1789236306	358 Count	803 Count	177 Count
1789236005	356 Count	797 Count	177 Count
1789235704	354 Count	794 Count	176 Count
1789235403	350 Count	786 Count	174 Count
1789235102	349 Count	781 Count	174 Count
1789234802	347 Count	777 Count	174 Count
1789234501	344 Count	768 Count	172 Count
1789234200	341 Count	762 Count	171 Count
1789233899	340 Count	760 Count	171 Count
1789233599	336 Count	752 Count	169 Count
1789233298	335 Count	748 Count	169 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)