EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789208992	90 Count	151 Count	45 Count
1789208691	89 Count	150 Count	45 Count
1789208390	84 Count	141 Count	42 Count
1789208089	83 Count	139 Count	42 Count
1789207788	80 Count	136 Count	41 Count
1789207487	77 Count	128 Count	39 Count
1789207187	74 Count	122 Count	38 Count
1789206886	73 Count	121 Count	38 Count
1789206585	68 Count	113 Count	35 Count
1789206284	67 Count	111 Count	35 Count
1789205984	64 Count	107 Count	34 Count
1789205683	61 Count	100 Count	32 Count
1789205382	58 Count	95 Count	31 Count
1789205081	57 Count	94 Count	31 Count
1789204781	52 Count	86 Count	28 Count
1789204480	50 Count	82 Count	27 Count
1789204179	47 Count	80 Count	26 Count
1789203878	44 Count	75 Count	25 Count
1789203572	43 Count	75 Count	25 Count
1789203271	41 Count	74 Count	25 Count
1789202970	38 Count	68 Count	23 Count
1789202669	34 Count	63 Count	21 Count
1789202369	27 Count	51 Count	15 Count
1789202068	23 Count	42 Count	13 Count
1789201767	21 Count	39 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)