EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1773691329	53 Count	277 Count
1773687726	48 Count	259 Count
1773684123	43 Count	243 Count
1773680520	38 Count	230 Count
1773676917	33 Count	192 Count
1773673318	28 Count	156 Count
1773669749	23 Count	112 Count
1773666146	18 Count	89 Count
1773662543	13 Count	62 Count
1773658940	8 Count	42 Count
1773655337	3 Count	22 Count
1773651735	177 Count	1024 Count
1773648131	173 Count	1000 Count
1773644528	169 Count	971 Count
1773640925	164 Count	938 Count
1773637322	159 Count	912 Count
1773633719	154 Count	879 Count
1773630116	149 Count	850 Count
1773626549	144 Count	825 Count
1773622946	139 Count	796 Count
1773619343	134 Count	768 Count
1773615740	129 Count	740 Count
1773612137	124 Count	710 Count
1773608534	120 Count	685 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)