EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1779030049	98 Count	862 Count
1779026481	93 Count	824 Count
1779022878	88 Count	782 Count
1779019275	83 Count	741 Count
1779015672	78 Count	698 Count
1779012069	73 Count	652 Count
1779008466	68 Count	605 Count
1779004863	63 Count	565 Count
1779001260	55 Count	501 Count
1778997657	49 Count	453 Count
1778994054	44 Count	398 Count
1778990451	39 Count	341 Count
1778986848	34 Count	288 Count
1778983282	29 Count	250 Count
1778979680	24 Count	211 Count
1778976077	19 Count	168 Count
1778972474	14 Count	125 Count
1778968871	9 Count	82 Count
1778965268	4 Count	40 Count
1778961665	136 Count	1011 Count
1778958062	132 Count	977 Count
1778954459	128 Count	945 Count
1778950856	124 Count	913 Count
1778947253	111 Count	886 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)