EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1767296709	109 Count	842 Count	80 Count
1767294909	106 Count	805 Count	78 Count
1767293108	103 Count	748 Count	76 Count
1767291308	99 Count	713 Count	73 Count
1767289507	95 Count	668 Count	70 Count
1767287706	91 Count	625 Count	67 Count
1767285906	83 Count	584 Count	60 Count
1767284105	79 Count	551 Count	57 Count
1767282304	74 Count	509 Count	53 Count
1767280510	66 Count	469 Count	50 Count
1767278710	62 Count	442 Count	47 Count
1767276909	58 Count	421 Count	44 Count
1767275108	54 Count	397 Count	41 Count
1767271507	46 Count	348 Count	35 Count
1767269706	42 Count	322 Count	32 Count
1767267906	38 Count	298 Count	29 Count
1767266105	34 Count	273 Count	26 Count
1767264305	27 Count	241 Count	20 Count
1767262504	23 Count	194 Count	17 Count
1767260704	19 Count	139 Count	14 Count
1767258909	8 Count	65 Count	8 Count
1767257109	113 Count	1061 Count	97 Count
1767255308	106 Count	995 Count	91 Count
1767253507	97 Count	928 Count	83 Count
1767251707	88 Count	857 Count	75 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)