EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1769018840	111 Count	536 Count	94 Count
1769017039	105 Count	496 Count	89 Count
1769015239	98 Count	454 Count	83 Count
1769013438	88 Count	384 Count	74 Count
1769011637	77 Count	324 Count	64 Count
1769009837	68 Count	280 Count	56 Count
1769008036	60 Count	250 Count	49 Count
1769004449	44 Count	202 Count	39 Count
1769002648	37 Count	165 Count	33 Count
1769000847	31 Count	142 Count	28 Count
1768999047	21 Count	110 Count	19 Count
1768997246	13 Count	83 Count	12 Count
1768993645	136 Count	1053 Count	121 Count
1768991844	125 Count	1000 Count	111 Count
1768990044	116 Count	927 Count	103 Count
1768986435	94 Count	775 Count	83 Count
1768984641	78 Count	671 Count	72 Count
1768981039	55 Count	438 Count	51 Count
1768977438	32 Count	246 Count	30 Count
1768975638	23 Count	167 Count	22 Count
1768973837	11 Count	88 Count	11 Count
1768972037	132 Count	1028 Count	119 Count
1768970236	119 Count	939 Count	107 Count
1768968436	109 Count	860 Count	98 Count
1768966635	97 Count	753 Count	87 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)