EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1762379473	874 Count	874 Count
1762378873	862 Count	862 Count
1762378273	853 Count	853 Count
1762377673	844 Count	844 Count
1762377073	833 Count	833 Count
1762376473	824 Count	824 Count
1762375873	810 Count	810 Count
1762375272	800 Count	800 Count
1762374672	792 Count	792 Count
1762374072	780 Count	780 Count
1762373472	771 Count	771 Count
1762372872	754 Count	754 Count
1762372276	745 Count	745 Count
1762371076	724 Count	724 Count
1762370476	715 Count	715 Count
1762369876	702 Count	702 Count
1762369275	695 Count	695 Count
1762368675	683 Count	683 Count
1762368075	670 Count	670 Count
1762367475	660 Count	660 Count
1762366875	646 Count	646 Count
1762366275	635 Count	635 Count
1762365675	626 Count	626 Count
1762365075	612 Count	612 Count
1762364475	600 Count	600 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)