EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RX*	Digi*
1764457481	585 Count	302 Count
1764456881	583 Count	302 Count
1764456281	579 Count	300 Count
1764455681	573 Count	297 Count
1764455081	571 Count	297 Count
1764454480	567 Count	295 Count
1764453880	561 Count	293 Count
1764453280	559 Count	293 Count
1764452680	555 Count	291 Count
1764452080	549 Count	289 Count
1764451480	547 Count	289 Count
1764450880	544 Count	287 Count
1764450280	531 Count	277 Count
1764449680	520 Count	268 Count
1764449081	497 Count	246 Count
1764448480	473 Count	226 Count
1764447880	444 Count	199 Count
1764447280	384 Count	141 Count
1764446680	372 Count	133 Count
1764446080	369 Count	133 Count
1764445480	362 Count	127 Count
1764444880	357 Count	124 Count
1764444280	345 Count	114 Count
1764443680	341 Count	112 Count
1764443080	337 Count	110 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)