EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2KDS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2KDS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1793237658	14 Count	341 Count	2 Count
1793235857	13 Count	295 Count	2 Count
1793234056	11 Count	251 Count	1 Count
1793232256	10 Count	211 Count	1 Count
1793230455	9 Count	163 Count	1 Count
1793228654	8 Count	122 Count	1 Count
1793226887	3 Count	119 Count	1 Count
1793225085	2 Count	79 Count	1 Count
1793223285	0 Count	41 Count	0 Count
1793221484	80 Count	1011 Count	64 Count
1793219683	78 Count	971 Count	63 Count
1793217883	77 Count	922 Count	63 Count
1793216082	75 Count	878 Count	62 Count
1793214282	74 Count	832 Count	62 Count
1793212481	72 Count	788 Count	61 Count
1793210680	71 Count	747 Count	61 Count
1793208880	69 Count	699 Count	60 Count
1793207079	66 Count	643 Count	58 Count
1793205278	52 Count	554 Count	45 Count
1793203478	51 Count	515 Count	45 Count
1793201677	49 Count	471 Count	44 Count
1793199876	44 Count	413 Count	40 Count
1793198076	42 Count	371 Count	39 Count
1793196275	28 Count	279 Count	26 Count
1793194474	2 Count	181 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)