EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767282874	80 Count	950 Count	48 Count
1767281974	78 Count	935 Count	47 Count
1767281073	77 Count	930 Count	47 Count
1767280172	75 Count	901 Count	46 Count
1767279271	73 Count	858 Count	45 Count
1767278371	72 Count	852 Count	45 Count
1767277470	71 Count	830 Count	45 Count
1767276569	69 Count	791 Count	44 Count
1767275669	66 Count	746 Count	42 Count
1767274768	63 Count	713 Count	40 Count
1767273867	61 Count	700 Count	39 Count
1767272966	58 Count	685 Count	37 Count
1767272066	57 Count	656 Count	37 Count
1767271165	54 Count	646 Count	35 Count
1767270264	51 Count	598 Count	33 Count
1767269364	48 Count	558 Count	31 Count
1767268463	45 Count	504 Count	29 Count
1767267562	44 Count	474 Count	29 Count
1767266662	41 Count	433 Count	27 Count
1767265761	37 Count	382 Count	24 Count
1767264860	34 Count	326 Count	22 Count
1767263960	29 Count	283 Count	18 Count
1767263059	26 Count	238 Count	16 Count
1767262175	18 Count	194 Count	13 Count
1767261274	14 Count	147 Count	10 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)