EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PD-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PD-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767975279	27 Count	302 Count	17 Count
1767974378	25 Count	295 Count	16 Count
1767973477	19 Count	217 Count	11 Count
1767972577	14 Count	145 Count	7 Count
1767971676	13 Count	137 Count	7 Count
1767970775	9 Count	70 Count	4 Count
1767969875	4 Count	1 Count	0 Count
1767968990	50 Count	924 Count	39 Count
1767968090	42 Count	778 Count	32 Count
1767967189	40 Count	727 Count	31 Count
1767966288	33 Count	613 Count	25 Count
1767965388	28 Count	501 Count	21 Count
1767964487	27 Count	491 Count	21 Count
1767963586	22 Count	399 Count	17 Count
1767962685	18 Count	355 Count	14 Count
1767961784	15 Count	270 Count	12 Count
1767960884	11 Count	233 Count	9 Count
1767959983	7 Count	165 Count	6 Count
1767959083	3 Count	111 Count	3 Count
1767958182	79 Count	1122 Count	54 Count
1767957281	74 Count	995 Count	50 Count
1767956380	73 Count	983 Count	50 Count
1767955480	68 Count	899 Count	46 Count
1767954579	65 Count	860 Count	44 Count
1767953678	60 Count	804 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)