EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1751659903	65 Count	682 Count
1751659002	64 Count	666 Count
1751658101	63 Count	651 Count
1751657201	62 Count	638 Count
1751656319	61 Count	624 Count
1751655419	60 Count	608 Count
1751654518	59 Count	591 Count
1751653617	58 Count	581 Count
1751652715	57 Count	573 Count
1751651814	56 Count	565 Count
1751650914	55 Count	557 Count
1751650013	54 Count	548 Count
1751649112	53 Count	540 Count
1751648211	52 Count	533 Count
1751647310	51 Count	526 Count
1751646409	50 Count	518 Count
1751645509	49 Count	510 Count
1751644608	48 Count	501 Count
1751643707	47 Count	495 Count
1751642806	46 Count	487 Count
1751641905	45 Count	479 Count
1751641004	44 Count	473 Count
1751640103	43 Count	466 Count
1751639203	42 Count	450 Count
1751638302	41 Count	434 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)