EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ5STR-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ5STR-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1751357014	27 Count	341 Count
1751356113	26 Count	323 Count
1751355212	25 Count	308 Count
1751354311	24 Count	294 Count
1751353410	23 Count	279 Count
1751352509	22 Count	265 Count
1751351609	21 Count	246 Count
1751350708	20 Count	231 Count
1751349807	19 Count	223 Count
1751348906	18 Count	213 Count
1751348005	17 Count	202 Count
1751347104	16 Count	190 Count
1751346203	15 Count	173 Count
1751345323	14 Count	165 Count
1751344422	13 Count	154 Count
1751343521	12 Count	143 Count
1751342620	11 Count	130 Count
1751341719	10 Count	121 Count
1751340818	9 Count	110 Count
1751339917	8 Count	100 Count
1751339016	7 Count	86 Count
1751338116	6 Count	74 Count
1751337215	5 Count	62 Count
1751336314	4 Count	51 Count
1751335413	3 Count	42 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)