EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773179734	124 Count	596 Count	102 Count
1773178833	119 Count	561 Count	98 Count
1773177932	102 Count	522 Count	82 Count
1773177032	95 Count	496 Count	76 Count
1773176131	87 Count	466 Count	69 Count
1773175231	82 Count	440 Count	65 Count
1773173429	73 Count	350 Count	58 Count
1773172544	60 Count	320 Count	50 Count
1773171643	56 Count	295 Count	47 Count
1773170742	50 Count	268 Count	42 Count
1773169842	47 Count	247 Count	40 Count
1773168941	39 Count	220 Count	33 Count
1773168040	34 Count	191 Count	29 Count
1773167140	28 Count	163 Count	24 Count
1773166239	24 Count	134 Count	21 Count
1773165338	14 Count	103 Count	12 Count
1773164438	8 Count	68 Count	7 Count
1773163537	4 Count	36 Count	4 Count
1773162636	165 Count	1002 Count	141 Count
1773161736	156 Count	968 Count	133 Count
1773160835	152 Count	920 Count	130 Count
1773159934	146 Count	887 Count	125 Count
1773159034	141 Count	856 Count	121 Count
1773158133	133 Count	830 Count	114 Count
1773157232	123 Count	770 Count	105 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)