EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773175046	92 Count	675 Count	74 Count
1773173245	88 Count	650 Count	71 Count
1773171443	81 Count	615 Count	65 Count
1773169643	77 Count	560 Count	62 Count
1773167842	73 Count	525 Count	59 Count
1773166048	64 Count	500 Count	55 Count
1773164247	60 Count	473 Count	52 Count
1773162447	56 Count	441 Count	49 Count
1773160646	50 Count	405 Count	44 Count
1773158845	39 Count	363 Count	34 Count
1773157045	33 Count	330 Count	29 Count
1773155244	23 Count	263 Count	20 Count
1773153444	16 Count	193 Count	14 Count
1773146241	82 Count	948 Count	62 Count
1773144449	75 Count	887 Count	60 Count
1773142648	71 Count	820 Count	57 Count
1773140847	67 Count	758 Count	54 Count
1773139047	62 Count	690 Count	50 Count
1773137246	54 Count	617 Count	43 Count
1773135446	46 Count	545 Count	36 Count
1773128243	21 Count	247 Count	15 Count
1773126441	13 Count	168 Count	8 Count
1773124640	9 Count	72 Count	5 Count
1773122847	213 Count	1005 Count	177 Count
1773121046	205 Count	971 Count	170 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)