EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1789434676	2 Count	243 Count
1789432872	1 Count	164 Count
1789431070	0 Count	90 Count
1789429266	11 Count	1026 Count
1789427463	10 Count	944 Count
1789425660	9 Count	861 Count
1789422095	7 Count	694 Count
1789420291	6 Count	613 Count
1789418488	5 Count	521 Count
1789416685	4 Count	443 Count
1789414882	3 Count	367 Count
1789411275	1 Count	184 Count
1789409472	0 Count	90 Count
1789407668	10 Count	1068 Count
1789405865	9 Count	943 Count
1789404062	8 Count	844 Count
1789402293	7 Count	759 Count
1789400490	6 Count	655 Count
1789398686	5 Count	576 Count
1789396883	4 Count	487 Count
1789395080	3 Count	390 Count
1789393277	2 Count	285 Count
1789391474	1 Count	191 Count
1789389671	0 Count	95 Count
1789387868	9 Count	1024 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)