EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9DAT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1751763291	107 Count	361 Count	64 Count
1751762390	104 Count	350 Count	62 Count
1751761489	102 Count	337 Count	61 Count
1751760588	99 Count	330 Count	59 Count
1751759687	97 Count	316 Count	58 Count
1751758786	95 Count	310 Count	57 Count
1751757885	93 Count	296 Count	56 Count
1751756984	91 Count	289 Count	55 Count
1751756083	89 Count	278 Count	54 Count
1751753381	81 Count	256 Count	49 Count
1751752480	79 Count	246 Count	48 Count
1751751579	77 Count	239 Count	47 Count
1751750678	74 Count	228 Count	45 Count
1751749777	71 Count	221 Count	43 Count
1751747975	65 Count	198 Count	39 Count
1751745273	56 Count	151 Count	33 Count
1751744372	54 Count	138 Count	32 Count
1751743471	51 Count	120 Count	30 Count
1751742655	45 Count	108 Count	29 Count
1751741754	42 Count	91 Count	27 Count
1751739953	32 Count	68 Count	19 Count
1751739052	28 Count	55 Count	16 Count
1751738151	17 Count	31 Count	6 Count
1751737250	15 Count	24 Count	5 Count
1751736349	13 Count	19 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)