EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9DAT-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9DAT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1751554538	192 Count	823 Count	118 Count
1751553637	190 Count	822 Count	117 Count
1751552736	188 Count	821 Count	116 Count
1751550934	185 Count	820 Count	115 Count
1751550033	183 Count	819 Count	114 Count
1751549132	182 Count	819 Count	114 Count
1751548231	176 Count	814 Count	109 Count
1751547330	170 Count	809 Count	104 Count
1751546429	169 Count	809 Count	104 Count
1751545528	167 Count	808 Count	103 Count
1751544628	165 Count	807 Count	102 Count
1751543727	164 Count	807 Count	102 Count
1751542826	162 Count	806 Count	101 Count
1751541925	160 Count	805 Count	100 Count
1751541024	159 Count	805 Count	100 Count
1751540123	157 Count	804 Count	99 Count
1751539222	156 Count	804 Count	99 Count
1751538321	155 Count	804 Count	99 Count
1751537420	154 Count	804 Count	99 Count
1751536519	153 Count	804 Count	99 Count
1751535618	151 Count	803 Count	98 Count
1751534717	150 Count	803 Count	98 Count
1751533817	149 Count	803 Count	98 Count
1751532916	148 Count	803 Count	98 Count
1751532015	147 Count	803 Count	98 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)