EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1772097592	36 Count	301 Count	27 Count
1772095787	32 Count	275 Count	24 Count
1772093981	29 Count	246 Count	22 Count
1772092176	20 Count	214 Count	14 Count
1772090371	17 Count	187 Count	12 Count
1772088566	14 Count	161 Count	10 Count
1772086760	11 Count	126 Count	8 Count
1772084955	8 Count	98 Count	6 Count
1772083150	5 Count	61 Count	4 Count
1772081345	2 Count	27 Count	2 Count
1772079540	96 Count	1007 Count	64 Count
1772077734	93 Count	973 Count	62 Count
1772075929	90 Count	939 Count	60 Count
1772074124	87 Count	906 Count	58 Count
1772072319	84 Count	868 Count	56 Count
1772070514	81 Count	836 Count	54 Count
1772068709	78 Count	801 Count	52 Count
1772066904	75 Count	762 Count	50 Count
1772065098	72 Count	728 Count	48 Count
1772063293	69 Count	693 Count	46 Count
1772061488	66 Count	658 Count	44 Count
1772059683	63 Count	629 Count	42 Count
1772057878	60 Count	599 Count	40 Count
1772056072	57 Count	570 Count	38 Count
1772054267	54 Count	538 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)