EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6RJ-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RJ-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785073462	111 Count	951 Count	111 Count
1785072862	111 Count	948 Count	111 Count
1785072262	111 Count	945 Count	111 Count
1785071662	111 Count	942 Count	111 Count
1785071062	111 Count	923 Count	111 Count
1785070462	111 Count	913 Count	111 Count
1785069862	111 Count	907 Count	111 Count
1785069262	111 Count	902 Count	111 Count
1785068662	111 Count	897 Count	111 Count
1785068062	111 Count	892 Count	111 Count
1785067461	111 Count	888 Count	111 Count
1785066861	111 Count	887 Count	111 Count
1785066260	111 Count	882 Count	111 Count
1785065660	111 Count	879 Count	111 Count
1785065059	111 Count	875 Count	111 Count
1785064459	111 Count	873 Count	111 Count
1785063859	111 Count	869 Count	111 Count
1785063259	111 Count	866 Count	111 Count
1785062659	111 Count	860 Count	111 Count
1785062059	111 Count	857 Count	111 Count
1785061459	111 Count	855 Count	111 Count
1785060859	111 Count	850 Count	111 Count
1785060259	111 Count	847 Count	111 Count
1785059659	111 Count	846 Count	111 Count
1785059059	111 Count	843 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)