EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1773178648	23 Count	817 Count
1773177747	22 Count	760 Count
1773176846	17 Count	677 Count
1773175946	16 Count	616 Count
1773175045	11 Count	555 Count
1773174144	10 Count	417 Count
1773173242	6 Count	305 Count
1773172341	5 Count	262 Count
1773171441	0 Count	110 Count
1773170540	34 Count	1020 Count
1773169639	30 Count	883 Count
1773168738	29 Count	784 Count
1773167837	22 Count	741 Count
1773166936	21 Count	618 Count
1773166036	18 Count	531 Count
1773165135	15 Count	468 Count
1773164234	11 Count	371 Count
1773163333	10 Count	362 Count
1773162432	6 Count	256 Count
1773161531	5 Count	155 Count
1773160630	0 Count	39 Count
1773159729	29 Count	1143 Count
1773158829	25 Count	998 Count
1773157928	24 Count	918 Count
1773157027	18 Count	807 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)