EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1767303347	127 Count	500 Count	101 Count
1767302446	123 Count	486 Count	98 Count
1767301546	118 Count	469 Count	94 Count
1767300645	115 Count	457 Count	92 Count
1767299744	111 Count	442 Count	89 Count
1767298860	103 Count	428 Count	86 Count
1767297058	94 Count	400 Count	79 Count
1767296157	90 Count	385 Count	76 Count
1767295257	86 Count	369 Count	73 Count
1767294356	83 Count	347 Count	71 Count
1767293452	80 Count	333 Count	69 Count
1767289849	53 Count	233 Count	46 Count
1767288949	47 Count	211 Count	41 Count
1767288048	41 Count	188 Count	36 Count
1767287147	37 Count	158 Count	33 Count
1767286247	27 Count	114 Count	24 Count
1767285347	18 Count	84 Count	16 Count
1767284445	12 Count	62 Count	11 Count
1767283544	7 Count	40 Count	7 Count
1767282644	206 Count	1006 Count	164 Count
1767281743	200 Count	979 Count	159 Count
1767280842	194 Count	952 Count	154 Count
1767279942	190 Count	926 Count	151 Count
1767279041	181 Count	894 Count	143 Count
1767278140	176 Count	861 Count	139 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)