EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772386638	77 Count	383 Count	72 Count
1772385737	69 Count	335 Count	65 Count
1772384836	55 Count	273 Count	52 Count
1772383935	35 Count	208 Count	33 Count
1772383035	29 Count	165 Count	28 Count
1772382134	7 Count	74 Count	7 Count
1772380333	218 Count	988 Count	197 Count
1772379432	201 Count	894 Count	181 Count
1772378531	191 Count	806 Count	172 Count
1772377631	178 Count	758 Count	160 Count
1772376730	168 Count	718 Count	151 Count
1772375833	153 Count	665 Count	137 Count
1772374928	139 Count	611 Count	124 Count
1772374028	133 Count	561 Count	119 Count
1772373127	111 Count	511 Count	98 Count
1772372226	105 Count	491 Count	93 Count
1772371326	89 Count	409 Count	78 Count
1772370425	85 Count	351 Count	75 Count
1772369525	65 Count	297 Count	56 Count
1772367738	41 Count	214 Count	38 Count
1772366838	34 Count	158 Count	32 Count
1772365937	16 Count	84 Count	15 Count
1772365036	5 Count	38 Count	5 Count
1772364136	214 Count	1046 Count	183 Count
1772363235	203 Count	998 Count	173 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)