EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1KRF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KRF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1751763470	505 Count	804 Count	202 Count
1751762268	502 Count	799 Count	201 Count
1751761067	498 Count	793 Count	199 Count
1751759865	495 Count	789 Count	198 Count
1751758663	492 Count	786 Count	197 Count
1751757461	488 Count	781 Count	195 Count
1751756292	485 Count	776 Count	194 Count
1751755091	482 Count	771 Count	193 Count
1751753889	478 Count	765 Count	191 Count
1751752688	475 Count	760 Count	190 Count
1751751486	472 Count	755 Count	189 Count
1751750285	468 Count	748 Count	187 Count
1751749083	465 Count	743 Count	186 Count
1751747881	462 Count	738 Count	185 Count
1751746680	458 Count	732 Count	183 Count
1751745478	455 Count	727 Count	182 Count
1751744277	452 Count	720 Count	181 Count
1751743075	448 Count	714 Count	179 Count
1751741874	445 Count	709 Count	178 Count
1751740672	442 Count	704 Count	177 Count
1751739471	438 Count	698 Count	175 Count
1751738269	435 Count	693 Count	174 Count
1751737068	432 Count	688 Count	173 Count
1751735866	427 Count	681 Count	170 Count
1751734687	424 Count	676 Count	169 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)