EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP1KRF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KRF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1749186391	478 Count	503 Count	195 Count
1749186213	477 Count	503 Count	195 Count
1749186191	477 Count	503 Count	195 Count
1749185075	474 Count	502 Count	194 Count
1749183872	471 Count	501 Count	193 Count
1749182671	467 Count	499 Count	191 Count
1749181469	464 Count	498 Count	190 Count
1749180267	461 Count	497 Count	189 Count
1749179066	457 Count	495 Count	187 Count
1749177865	454 Count	494 Count	186 Count
1749176663	451 Count	493 Count	185 Count
1749175462	447 Count	491 Count	183 Count
1749174260	444 Count	490 Count	182 Count
1749173058	441 Count	489 Count	181 Count
1749171857	437 Count	487 Count	179 Count
1749170655	434 Count	486 Count	178 Count
1749169482	431 Count	485 Count	177 Count
1749168281	427 Count	483 Count	175 Count
1749167079	424 Count	482 Count	174 Count
1749165877	421 Count	481 Count	173 Count
1749164676	417 Count	479 Count	171 Count
1749163474	414 Count	478 Count	170 Count
1749162272	411 Count	477 Count	169 Count
1749161071	407 Count	475 Count	167 Count
1749159869	404 Count	474 Count	166 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)